Rite Guys Heating and Cooling Inc. technicians will perform a 60-90 minute tune-up and professional cleaning including the following 26 procedures:

1. Blower Motor – measure amperage and voltage for proper operation
2. Thermostat – test for proper operation, calibrate, and level
3. Cleaning existing air filter (as needed)
4. Bearing – inspect for wear and lubricate
5. Inspect indoor coil if accessible
6. Confirm proper return air and size
7. Inspect Condenser Coil
8. Refrigerate – monitor operating pressures
9. Safety Devices – inspect for proper operation
10. Electrical Disconnect Box – inspect for proper rating and safe installation
11. Electrical Wiring – inspect and tighten connections
12. Test/inspect contactors for burned, pitted contacts
13. Inspect electrical for exposed wiring
14. Inspect and test capacitors
15. Inspect fan blade
16. Clean condenser coil and remove debris
17. Inspect service valves for proper operation
18. Measure Supply/Return temperature differential
19. Inspect ductwork for energy loss
20. Compressor – monitor, measure amperage and volt draw and wiring connections
21. Check Unit for Time Delay Relay
22. Check Unit for Isolation Pads
23. Inspect suction line for proper fittings
24. Inspect all fittings for signs of oil and/or leakage
25. Check lines and fittings with refrigerant leak detector
26. Check the condition of Blower Belt, if applicable